First of all, melt the wax. All wax has a flash point, so to prevent it bursting into flames, you must melt it in a double boiler, with water in the bottom pan.
Then, prepare the mould with the wick. Thread the wick through the mould and make sure that you leave a good few centimetres sticking out of the hole in the bottom.
After that, add the scent. If you want a scented candle, add a few drops of essential oil to the melted wax. You can use any essential oil you like, as long as it doesn’t contain water.
Next step, pour the wax into the mould. Try and tip the wax into the mould quickly, all in one go, to minimise spillage and air bubbles.
Then, release the bubbles and top it up. Releasing the air bubbles will eventually make the candle sink, so you will need to top it up with more melted wax.
Finally, remove it from the mould. After four or five hours, the candle can be taken out of its mould.
Your candle is now ready for display. Remember, you must always leave it for a day before lighting it.
This example of procedure text on how to make candles is taken from the source: www.channel4.com
I think that very clear enough to understand the generic structure of the procedure text above. Here is the summary.
1. Goal: Clearly the text is about how to make candles
2. Materials needed: Some are listed as
wax, moulds, wick, dye discs, essential oils, and a double boiler.
3. Sequenced steps: What step by steps should be followed to make candles
melt the wax, prepare the mould with the wick, add the scent, pour the wax into the mould, release the bubbles and top it up, remove it from the mould.
Well that’s all about procedure text example. This is good to practice make the candles as well to understand the instruction. Learning English by doing is advantageous.